The processing of the mirror axis is very worth learning for us because it is the product of the website and the keywords. In addition, through it, we can familiarize ourselves with the website and the manufacturer, and at the same time, we can also add some Expertise. Therefore, considering these factors, we have reached the above conclusions. Therefore, to respond in a timely manner, it is not too late to start learning and improve learning efficiency.

1. In the mirror axis machining, if the mirror axis is 10, can it be used with the coupling?

In this case, Longfeng mechanical mirror shaft processing manufacturers believe that this is impossible because its value is too small to be realized. In addition, the aperture is as high as 10.02, which can be combined with the mirrored journal structure for smooth operation.

2. What equipment can be used to machine the front chamfer during the processing of the mirror axis? Can the internally threaded hole be machined on the mirror shaft end?

In the mirror axis machining, the front end chamfer of the shaft can be machined by lathe or chamfering machine, and the processing effect is the same, achieving the same processing purpose. The machining of the threaded bore at the mirror end is any machining of the mirror shaft. So, in the second question, the answer is yes

3, mirror axis processing, its processing level, mainly depends on what? What is the power of the machining center spindle motor?

The level of processing of the mirror axis depends primarily on the importance of the part and its compatibility requirements, which in turn determine the level of processing of the mirror axis. However, in general, it takes 5 to 7 levels. The spindle motor power of the machining center reflects the cutting speed and cutting torque capability of the machining center. In addition, the processing capacity of the machining center can also be judged.