How to drill and install a disc in mirror shaft machining?

In the mirror axis processing, the following will continue to study in this area, because this is what we hope, so we can get some new knowledge from it, and at the same time, increase our own expertise in this area, so that we have Benefits, then why not take it seriously? go a head!

1. The processing of the mirror axis. If you drill in, what are the common methods?       

The machining of the electronic axis is the processing of the mirror axis. If you are drilling, there are some common methods. Specifically, it is drilled or drilled on an electric lathe if the aperture is not large. However, it should be noted that the machining of the drill bit and the mirror axis should be ambiguous.

2. Why is the material of the mirror axis the same? What is the professional name of the hole at both ends? What is its role?

The material of the mirror shaft is like a 40CR tempering material, but in the processing of the mirror shaft, the key groove is easily cut. Therefore, we should pay attention to this and avoid it. The holes at the ends, whose professional name is used for the top or machined holes, are usually used during processing.

3. How to install the disc on the mirror shaft?

In general, there are two ways to install a disc on a mirrored shaft. The seed is made such that the inner diameter of the disk is larger than the size of the mirror axis, and then the disk is mounted by heating. Secondly, it is processing the mirror axis and installing it through the keyway, but this is a bit of a hassle.

For the processing of the mirror axis, it can be said that the above problems are worthy of understanding and mastering in time, because this is also the necessary knowledge for us to fully understand, and at the same time, it has certain practicality, so we will draw this conclusion at the same time. E, we also hope that we strictly enforce, and then let us have a good learning effect.