For the mirror axis processing, next, mainly for the slender shaft, to carry out its understanding and understanding, in terms of processing. Moreover, this is also an important aspect for us, because it belongs to the mirror axis processing, so the above requirements will be met. So, next, let's talk about some of the precautions in the process of processing, or the aspects that need attention, so that everyone has a correct understanding.

In the mirror axis processing, for the shaft of the slender shaft, the precautions for the processing or the aspects to be noted, if summarized, then there are mainly the following:

Aspect: Pay attention to the method of clamping the workpiece

In general, when the rough machining of the mirror shaft machining is performed, since the cutting allowance is large, the cutting force received by the workpiece is also large. Therefore, in the workpiece clamping, the card top method and the elastic tip of the tailstock tip are used, so that the workpiece can be freely elongated in the axial direction. In high speed and large amount of cutting, it is not applicable, so Karafa should be used to avoid various problems.

Aspect 2: Use the appropriate tool holder

Since the tool holder is an important accessory in the processing of the slender mirror axis, it is necessary to use a suitable tool holder to counteract the influence of the radial cutting component during machining, thereby reducing cutting vibration and workpiece deformation. However, it should be noted that the center of the tool holder should be kept at a higher level than the center of the machine tool.

Aspect 3: Reverse feed can be used if necessary

In the mirror axis machining, the turning of the slender shaft is often the feed motion of the turning tool, so that the workpiece has a tendency to axially elongate. However, if a karaoke tool is used and reverse feed is performed, it is possible to avoid the problem that the elongated shaft is bent and deformed. Moreover, on the turning tool, there are different requirements for roughing and finishing, so different turning tools should be used.